How to Work a Magic Loop (and Why!)

The magic loop in crochet goes by many names. You may have heard it called magic ring, magic circle, disappearing loop, and more. Learn how to make the crochet magic loop.

The magic loop is actually quite magical. It’s easy once you get the hang of it, and it’s much neater and tidier than the standard chain-4 loop that many crochet patterns start with. The biggest advantage of the magic loop is that you can cinch it tight to make the center of your ring or project close to invisible.

As you can see above there is a marked difference between the circles started with a magic loop (on the top) versus a chain 4 loop (on the bottom). You can use the tail end of the magic loop to cinch up the circle to make the tiniest hole that works for the yarn. The smaller the yarn the smaller the final hole will be. You can use a magic loop to begin any project that starts in the round. The only time I would advise against a magic loop is if you need that larger opening for decorative or useful purposes. So let’s learn how to work a magic loop step by step.

STEP ONE

Place the tail of the yarn in your palm with the end hanging off the bottom edge of your palm as shown. The working yarn should be draped over the top edge of your hand as shown with the yarn hanging down over the back of your hand.

STEP TWO

Wrap the working yarn back over your index and middle fingers, making an X as shown with the working end of the yarn hanging down over the back of your hand again. Use your ring finger and pinky finger from your left hand to hold down the tail yarn and keep the tension on the loop.

STEP THREE

Insert your hook from right to left under the X.

STEP FOUR

Use the hook to pull through a loop from the working yarn.

STEP FIVE

And then yarn over to chain one to close the loop.

STEP SIX

Carefully remove the loop from your fingers with the doubled strands and the tail end to the left. Begin to work stitches directly into the magic loop, making sure that each stitch is worked around the two strands that run along the top of the magic loop.

STEP SEVEN

Pull gently on the tail to close up the magic loop.

And that’s all you do! It’s broken down into seven steps, but you’ll find once you practice them that you will move smoothly and quickly from one step to the next. Pay attention to your pattern, as sometimes it will call for chaining more stitches before you work the actual stitches into the magic loop. And now you are a crochet magician!

Discussion
  • (will not be published)

7 Responses to “How to Work a Magic Loop (and Why!)”
    • Nancy McKinney
      Nancy McKinney

      I have an easier way to make the circle–from a pattern I recently used: Wrap yarn aroundindex finger. Insert hook into ring on finger, yarn over and draw up a loop. Carefully slip ring from finger and work the stitches of Rnd 1 into the ring. That’s it. You can pull the end to tighten the loop.

      Reply
  1. Judith Martin
    Judith Martin

    I seldom see left handed advice or directions. We lefties love to crochet, too!

    Reply
  2. MARJORIE DUNBAR
    MARJORIE DUNBAR

    This is amazing when the step and instructions are so clear and precise. thank you

    Reply