Starting Double Crochet Rows

Most times, when working in double crochet, we are told to chain three and turn, use that chain three as the first double crochet in the row, then begin by placing a double crochet in the second stitch and moving forward. While that works, sometimes it can leave a gap at the beginning of each row, that doesn’t look so attractive. While some folks try to work a chain two instead of a chain three, that can pull your edges down and make them pucker (depends on your gauge of course – it does work for some people).

The two techniques I use most often to get rid of those gaps are to either use a linked double crochet or a wrapped double crochet for the beginning of a double crochet row.

Linked Double Crochet

For the linked double crochet, you will chain 3 and turn, and that chain will replace the first double crochet in the row, but instead of beginning your next double with a yarn over, you will insert your hook front to back through the second chain of that chain three, yarn over and draw up a loop, then finish your double as you would normally (insert your hook in the next stitch, yarn over, draw up a loop, yarn over and draw through two loops on hook twice). By linking the first completed double to the chain-three, you close that gap.

Wrapped Double Crochet

Alternatively, you could begin with a wrapped double crochet. Chain two and turn, wrap the hook around the back of that chain-two and yarn over, bringing the hook back to the front of the work, insert your hook in the very first stitch, and finish your double as above. The chain-two and the wrap extend a bit past the edge of the work but because you are starting your row proper with an actual double crochet instead of a chain three, the gap disappears.

Try one of these techniques the next time you’re working in double crochet!

Share tips, start a discussion or ask one of our experts or other students a question.

Make a comment:
500 characters remaining

23 Responses to “Starting Double Crochet Rows”

  1. Maggie Mula

    The way I like to start a dc row is by doing a dc decrease. After you ch 3, do a decrease in the next two stitches. Keeps the stitch count correct and keeps spacing needed!

  2. Susan Peterson

    And then how do I end it without having a drastic change? ex. My first hat end up with an uneven finish when my FPDC/BPDC was done and I fastened off.

  3. Raquel

    Thank you for these awesome tips. I have always hated that gap so I am excited to try both of these techniques!!!

  4. Cathy Matrisotto

    I do two chains and pull them tight. Then I do a dc in the first stitch.

  5. Katherine jones

    I prefer a stacked sc in place of a ch3 to start either a hdc or dc row. You don’t have the gap and you have the top of a regular stitch on your return row instead of a chain. It makes a nice even row end

  6. Patricia

    Good to know!

  7. Shirley

    Thanks!

  8. Micki Dalton

    Thanks for the tips

  9. Arlene Brown

    Thanks for the tip

  10. Margarita Rickard

    Excellent advice I’ve been looking for a way to take away that gap. Thanks